Surge Protection
The main job of a surge protector system is to protect electronic devices from "surges." So if you're wondering what a surge protector does, the first question is, "What are surges?" And then, "Why do electronics need to be protected from them?"
A power surge, or transient voltage, is an increase in voltage significantly above the designated level in a flow of electricity. In normal household and office wiring in the United States, the standard voltage is 120 volts. If the voltage rises above 120 volts, there is a problem, and a surge protector helps to prevent that problem from destroying your electronic devices.
- When the increase lasts three nanoseconds (billionths of a second) or more, it's called a surge.
- When it only lasts for one or two nanoseconds, it's called a spike.
- If the surge or spike is high enough, it can inflict some heavy damage on a machine.and electronic devices
- Homes are in more need of whole house surge protection today than ever.
- A lot has changed in the home over last few years, There are many more electronics, and even in lighting with LEDs, if you take an LED apart there’s a little circuit board there. Washers, dryers, appliances also have circuit boards today, so there’s a lot more today to be protected in the home from power surges—even the home’s lighting. “There’s a lot of technology that we’re plugging into our houses.”
-
Lightning isn’t the biggest danger to electronics and other systems in the home.
-
Most people think of surges as lightning, but 80 percent of surges are transient [short, intense bursts], and we generate them ourselves, They’re internal to the home. Generators and motors like those in air conditioning units and appliances introduce small surges into a home’s electrical lines. It’s rare that one large surge will take out appliances and everything at one time, but those mini-surges over the years will add up, degrade the performance of electronics and cut short their useful lifespans.
Overvoltages on the utility lines can also harm systems in the home, which is a prime reason for whole-house surge protection at the electrical service panel.
There is virtually no surge protection for a direct lighting strike. If you’re concerned about that, look into lighting rods.
-
Whole house surge protection should be layered.
If an appliance or device sends a surge through a circuit that’s shared among other devices and not dedicated, then those other outlets could be susceptible to a surge, which is why you don’t want it just at the electrical panel. Surge protection should be layered in the house to be at both at the electrical service to protect the whole home and at the point of use to protect sensitive electronics. Power conditioners with surge suppression capability, along with the ability to provide filtered power to audio/video equipment, are recommended for many home theater and home entertainment systems.
What to look for in whole house surge protection devices
Most homes with 120-volt service can be adequately protected with a 80kA-rated surge protector. Chances are a home is not going to see large spikes of 50kA to 100kA. Even nearby lightning strikes traveling over power lines will be dissipated by the time that surge reaches a house. A home will likely never see a surge over 10kA. However, a 10kA–rated device receiving a 10kA surge, for example, could use up its MOV surge-shunting capacity with that one surge, so something in the order of 80kA will ensure it lasts longer. Homes with subpanels should have added protection of about half the kA rating of the main unit. If there’s a lot of lightning in an area or if there’s a building using heavy machinery nearby, look for an 80kA rating
Sycom Surge protector SYC-120-240-T1
Has a lifetime replacement warranty on the unit
and $50,000 connected equipment warranty.
if you don't see any lights on the unit it's no longer protecting and needs replacement. Just send it back and Sycom will replace it.
Click to download PDF warranty document.
Understanding surge protection warranty
